Several different holders that allow you to attach a variety of things to the DIN rail. For all the parts, I used PETG. If possible, arrange the parts on the bed so that the layers of plastic in the places of bending parts, during operation, experience longitudinal, rather than transverse loads. I recommend treating these areas with a hair dryer before use. I made two versions of the PCB vice: made from one part and a composite of two, because after printing it may be too difficult to remove the supports. In addition to printed parts and DIN rails, you will need M6 and M4 bolts and nuts for them. Some of the parts are suitable from another project of mine without alteration https://www.thingiverse.com/thing:6693389 Video https://www.youtube.com/watch?v=nrW-S6quhOs
Category: ToolsThe author marked this model as their own original creation. Imported from Thingiverse.