Anycubic Vyper wastebin + bracket

My own design of a wastebin with magnetic bracket - the bin fits on the left front frame and can be fixed with T-nuts there, the bin is held by two 6x2mm magnets on the bracket and on the bin. When the printhead is in home position, any “poop” coming out during heatup or filament change can be collected in the bin. To avoid hot filament melting in the bin, I simply use a piece of paper laid down in the bin.

I printed this for all of my Vypers with PLA+ recommended layer height 0,2mm

For full assembly you will need 

4 x Screw M3 or M4 x 16mm

4 x T-Nut M3 or M4

4 x Magnet 6mm diameter 2mm thick

a bit of superglue