Triceps Barbell adapter: 30mm threaded to 50mm / 2 inch Olympic

Copyright (C) 2020 Peter Senna Tschudin

SPDX-License-Identifier: GPL-2.0-only

This design is distributed in the hope that it will be useful, 
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

USE AT YOUR OWN RISK!

Triceps Barbell adapter: 30mm threaded to 50mm / 2 inch Olympic

ATTENTION!!!

Double check dimensions of your barbell before printing. Each of these are 10 hours+ prints, and it is a tight fit formy barbell:

My barbell screw:

29.65 mm external diameter My barbell screw thread:

6.5 mm pitch

• 3.5 mm wide

1.5 mm deep I keep the sources on github

Print Settings

Rafts: No

Supports:  No

Resolution: 0.2

Notes:  Sliced with PrusaSlic3r using the 0.2mm speed profile. PETG, 10 top solid layers, 10 bottom solid layers, 6 perimeters, no supports.