Hollowed Deathstart ornament

remixed the Deathstar ornament for easier resin printing, hollowed out so the model will be lighter and an be hung on a tree. Less post processing since the area contacting the two halves in reduced. so less area to cleanup.

When printing with resin make sure to use sure there is an air gap to the middle of the model to avoid cupping.  This can be done with a build plate that has perforations, or using supports and lifting off the build plate. To avoid losing detail ensure supports only contact the middle area or the inside. 

Hollowed out the two halves so it's easier to print on a resin printer and wouldn't be too heavy to hang on a tree.