Logitech C270 IKEA Stankregn integration

This mount allows for integration of Logitech C270 camera with IKEA Stankregn lamp.
 

Instructions:

1. Print both elements, use 0.2mm layer height - it will ensure a single layer bridging when changing mounting holes diameter. Clear holes for M3 screws.
2. Disassemble Logitech camera, de-solder shield connection, remove cable and camera PCB.
3. Solder the shield connector on the opposite side it was soldered originally.
4. Cut a clean filament piece and place it inside the hole for the LED (left side of camera hole)
5. Mount the camera PCB to the front plate using two original screws
6. Optionally for a common power supply cut IKEA Stankregn cable to a length and solder it to camera PCB power supply rails (5V rail from USB, Stankregn white is +5V, black is GND)
7. Slide rubber camera cable mount into a slot in the back piece. and optionally do accordingly with Stankregn cable.
8. Screw both pieces using four M3 nuts and M3x10 screws