Bike Accessory Storage Rack - Inspired by Tons Gear Organizers

Overview:

This system was designed for a college independent study and was inspired by the Tons Gear Organizer product. It is designed to work with a 1" (specifically, 24.6 mm) wooden dowel to fasten onto your wall in either a horizontal or vertical format. 

Materials:

• Recommended print material: ASA, ABS, PETG
• 1" Wooden Dowel
• Generic drywall screws
• Generic drywall anchors
• M3 Screws (optional)
• M3 Nuts (optional)

Print instructions:

• No support
• .1-.2 mm layer height
• Brim (hooks, glasses holder)
• High infill / 2+ wall perimeters (you want it to be strong!)

Assembly instructions

Glasses holder:

The glasses holder is designed to be used with a vertically mounted dowel. It is recommended to install the holder before installing the dowel on the wall. Slide the holder onto the dowel before installing the dowel into the wall. Then, to achieve your desired level of tightness, insert an M3 nut into the hexagonal hole on the rear interface of the holder, then screw an M3 screw through the hole and nut to secure the holder in place.

Computer holder:

The computer holder is designed to be used with a vertically mounted dowel. It is recommended to install the holder before installing the dowel on the wall. Slide the holder onto the dowel before installing the dowel into the wall. Then, to achieve your desired level of tightness, insert an M3 nut into the hexagonal hole on the rear interface of the holder, then screw an M3 screw through the hole and nut to secure the holder in place

Helmet hook:

The helmet hook is designed to be used with a horizontally mounted dowel. It can be installed before or after the dowel has already been mounted. To attach the hook onto the dowel, find the arrow on the back of the hook, ensure that it is pointing up ^, then snap the hook onto the dowel. 

Shoe hook:

The shoe hook is designed to be used with a horizontally mounted dowel. It can be installed before or after the dowel has already been mounted. To attach the hook onto the dowel, find the arrow on the back of the hook, ensure that it is pointing up ^, then snap the hook onto the dowel. 

Wall fastener (2 part):

The 2 part wall fastener is designed to mount the dowel to the wall in either a horizontal or vertical format. First, use your desired length of drywall screw and anchor to mount two of the “Wall Fastener Part 1” on to the wall, ensuring they are level / aligned with each other. Next, insert M3 nuts into the hexagonal slots in each “Wall Fastener Part 2”. Then, slide each “Wall Fastener Part 2” onto the wooden dowel. Last, use an M3 screw to align and screw each of the two wall fastener parts to each other, and tighten to your desired tightness.

One part wall fastener:

The one part wall fastener is designed to mount the dowel to the wall in either a horizontal or vertical format. First, use your desired length of drywall screw and anchor to mount two of the “One part wall fastener” on to the wall, ensuring they are level / aligned with each other. Then, brace the wall fasteners as you slide the wooden dowel through each wall fastener.

Perpendicular wall mount:

The perpendicular wall mount can be screwed into drywall / studs, and is designed to have a very tight tolerance between the dowel and 3D printed interface. It is recommended to use a mallet to fully insert your desired length of dowel into the perpendicular wall mount.