Fits nicely. Using an 8020 fan and 35mm TPU feet.
Sovol SV08 Elecronics 8010 fan mount
Mounts the fan in a slightly elevated position to give enough room to breathe, even with the original feet.
55
284
5
1074
updated
April 19, 2026
Makes
Comments
I've tried another competing design but I found it pressed too hard on the mainboard's wires. This design is perfect. I'm using an 8015 fan instead of an 8010 because it's what I have and because my feet are a little taller than stock. Printed in black ASA because that's what I had loaded already in another printer. Probably PLA would be fine too. (edited)
Works good, printed in PETG. Used printable t-nuts to secure to the extrusion.
Printed mine in Filaxix white PETG-GF. One question though, how did you secure the lower two legs to the rail? (edited)
Did mine in polymaker ABS, turned out great and fits perfect. I added a 8020 be quiet fans because I have taller feet on mine. (edited)
