Creality K1-Max/K1C Camera LED Ring

Creality K1-Max/K1C Camera LED ring snap on cover to shine some light on the nozzle area below shaded area below the extruder. 
K1 can support the same camera if bought as addon.

Note, Doing a home operation on the printer will make the extruder just touch the cover top corner, but it does work fine.

Printed without support, added mouse-ears brim on textured PEI plate. 
Used Hyper PLA as temperatures should be humane around the camera.

Used 24V 8mm COB LED strip, with cut size for three segments measuring 115mm to wrap around the shroud cover.
When soldering the cable to the LED strip connectors, solder both sides to hold the strip in place properly, I also added som hot glue to seal the open terminals.

When upgraded the other lights, added a JST connector header for the camera LED ring separately, hot glued it to the printer inside the door for easy access as my cable was a abit short and the connector itself did not fit behind the Y axis assembly against the right side panel.