Christmas tree lamp - vase mode shade

A Christmas tree lamp that you can print and assemble to decorate during the holidays. It uses vase mode but you can still make it taller than your printer's max height. 

• Print the shades in Spiral Vase mode using a 0.4 or 0.6 mm nozzle at any layer height (we used 0.28). 
• The Stems and base part need to be printed normally.
• The parts should fit tightly so no glue is required. However, you can use a drop of super glue if you like.
• Use any LED strip 8 to 10 mm wide. Cut at the desired length. 
• Scale it up to any size you want!

Additional notes: 

• Be careful when removing the vase-mode parts from the print bed! Do not pull them from the sides, use a scraper and carefully separate them from underneath instead.
• The stem parts are labeled so it is easy to know in which order they should go.

EDITs:

• 20241210: 
  • Added missing file Stem_3_stop.stl 
  • Re-uploaded Level6.stl
• 20241211:
  • Uploaded three sets of parts for the stem or trunk with different clearances:
    • Fit (recommended): 0.15 mm
    • Loose: 0.25 mm
    • Tight: 0.05 mm
• 20241216:
  • Added a new version of the star top which shines through. It is still compatible with the old model, you only need to print a new Level6.stl and the new files under star_shine folder