Derailleur Pulley Wheel

Remix from "SRAM GX EAGLE Pulley wheel" - I found the teeth to be too wide, wouldn't fit the chain. Also I found issues with printing support…the teeth were not smooth enough after removing the supports. So this is HALF of a pulley wheel. Print two, and use super glue to join them for a complete wheel. Will work with chains up to 12 speed, including SRAM AXS flattop.

Photo shows stages of completion. The two halves at bottom, after gluing together in the middle, and with bearing up top. (Also shown is M6 bolts and some spacers, for the project I was working on…not for use on a bike.)

0.2 mm layer height

I found the teeth to be too wide in the original, so this has narrower teeth.