There exists a lot of fancy LED holders for the MINI, however most of them use LED stripes or SMD LEDs. This one uses a standard 5mm white through hole LED - one that probably everyone has at home ;) A resistor can be soldered directly to the LED and can be connected to the 3.3V supply of the buddy board. There should be enough space to fit everything inside.
The holder prints in place and has a lid that can be bend over.
A M3x10 screw is required.
Of course, there are much brighter variants and ones that have a more uniform illumination of the build plate.
The author marked this model as their own original creation.