Springy Flower Collection Update

UPDATE: Valentine's Day Flowers are available here: https://www.printables.com/model/1155813-valentines-day-flowers-springy-flower-collection

UPDATE: A Venus Fly Trap is now available here: https://www.printables.com/model/1131925-venus-fly-trap-springy-flower-collection.

This is an update to my original springy flower collection. I had a lot of fun with the original so I kept going with it.

This update adds a thicker springy dirt, a mushroom with 2 stems, a zinnia, 2 additional cactuses, a 3 position stem and 3 different size planters. All flowers fit all stems (except the cactus flower).

Do not scale down or the threads will not work! Print at a fine layer height such as .12mm.

I recommend the springy dirt be made out of ABS if possible or it might sag over time.

An outer brim is required on the cactus and cactus flower, flower stems, the daisy cap and tulip. The 3 position stem is also available will support structures to make printing easier.

Pick your planter size then the springy dirt snaps into the planter. Then pick your stem and flower (or the cactus) and screw it into the dirt.

The models shown were printed with ABS using a .12mm resolution.

Please like and upload a make!