Great design. I was about to create my own adapter then I found this one. I use it as is on my A10. Printed with ASA.
I used a 6 mm eccentric nut instead of the stock one on the A10: I save a bit of space on the Y axis. The only mob I might do is to raise the support for the belts by few mm so they are closer to the extruder. The original grantry has the same issue.
Hey, today i needed your design for my rebuild of my old CR6-se. i couldnt use the ender 3 after burner mods because they required the faceplate i dont have. your design worked out great but i had some minor issues. they can be easily fixed in CAD. one was: the ender series printer use other V roller than the ones u got. i was not able to put the excentric nut into the Vroller. so i drilled a 7mm hole in the faceplate and put the excentric part into that. also the spacer where the wrong length because of that. i used one nut and one spacer. the plate still has some incline but its okay. maybe different lenght spacers would be a nice add. other than that your design is very nice. im still impressed how stable it is :D
@Res16_193059 This is awesome! how did you mount the extension board? is there a specific afterburner to use? I have an A20m that could use this.
@Res16_193059 Is that a stealthburner? I can't quite figure out if it uses the same mounting as the afterburner, the internet is no help ;;
