Printer Rocker for 2020 4020 4040 Extrusion

The rocker is deisgned to help rotate a printer onto its back to allow for easy access to electronics.

It is inspired by similar Rock n Roll mods for Voron printers.

Printing with 0 bottom and 0 top layers can give for a nice effect, especially when combined with 35% hexagon infill.

Hardware required:

• 4x M4x10mm screws
• 4x M4 t-nuts or drop in nuts

You could use M3 or M5 hardware, as long as the screw is 10mm in length.

The attached file is for the right side, don't forget to mirror it for the left side.