Ender 5 Plus Mercury One.1 Enclosure Top-Hat

This is a 3D printed top-hat to enclose an Ender 5 Plus Mercury One.1

To use the top-hat enclosure, you will need the following:

• Inside Frame Stepper Mounts https://www.thingiverse.com/thing:5996645
• Fizzy Tech's Panel Clips for 2020 Extrusions https://www.thingiverse.com/thing:5996645
• 6mm total thickness panels (3mm thick panels + 3mm foam tape) - refer to the PDF for tested sizes

The design uses printed dowels, which may require resizing. If I recall correctly, the default size at 100% scaling is too loose.

The only hardware required is some M5 bolts to attach to to the tapped holes at the front of the extrusions and some M4 bolts and t-nuts (6 of each M4 hardware).

You'll need to mirror the bottom corners and top corners.

Special thanks also to the Zero G group for their Mercury One.1 design.

If you've got any questions, please let me know :)