Jetstream Sam's HF Katana - Murasama

This is one of the first models I've made i am a amateur and any recommendations are appreciated

The Sword is 110cm long or about 43 inches

This Model will be updated and improved over time.

The sword is cut into printable bits including the blade which is cut into 8 sections

Each part is held together with the others with pins i would suggest gluing the pieces together with the pins to make them stay correctly orientated.

The 10mm pins are for everything - 20 are needed
The 60mm pins are for the handle, guard and blade collar - 2 are needed

print blades pointing upwards, if you want stronger pins use more walls/perimeters and change orientation to be on their sides brim is recommended

Print Settings:

no supports

infill: 15% - Adaptive Cubic