Crowntail Betta | HueForge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.4mm

The Model is 75.32x100mm in size
You may print at higher layer heights below the Min Depth of 0.56mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
PLA BambuLab Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #6 (0.8mm) swap to Blue Gray
At layer #7 (0.88mm) swap to Red
At layer #15 (1.52mm) swap to White for the rest.