Pokemon TCG Tin box Insert

I recently went through my Pokémon cards to make a deck, and realized that I didn't have a box for them.  I could use the many (very nice) 3dprinted deck boxes on this site, but I wanted to use some of my old card tins.  I used the measurements of the Dagonite tin, but they should all fit the same. (note that some tins are taller and might need a riser to lift them up… or just print two and stack them!)

Also included is a ‘lid’ of sorts to hold the cards. I have inverted the tin, had it loose in the back of a backpack, etc., and the lid held the cards nicely in the print.  

I made the insert the size of a cardboard deck box, so it should fit snug but loose enough to easily get the cards out. No idea if they will fit with sleeves because I simply do not own any sleeves 

(EDIT! I recently got some official Pokémon sleeves this weekend from an anime convention, and the default size is JUST a bit too small.  there is some space, so you should be able to print the model at 103% - 105% and it should all fit just fine with the sleeves)