doTerra essential oils box

I designed this Box so that my mother could store all of her essential oils in it. The dimensions are taken from the doTerra 15ml and 5ml oil bottles. It's got space for 30x 15ml and 7x 5ml. As long as oil bottles from other brands are the same dimensions or smaller, they will fit too.

There are two lid versions: one has a flat bottom, the other one a doTerra cutout. You print the doTerra Logo first, then the lid right over it. Just don't forget to align them in your Slicer so that the Logo goes right in the cutout of the lid.
I used a nail with a 2,5mm diameter as hinge.
The clip is a bit tricky, you have to print it on it's side with 4 walls, 100% infill, supports and be very gentle tightening the screws (M3 10mm) as it will crack easily.

3D printing settings

Layer Height: 0,2mm (at least initial layer when you print the logo)
Walls: 2
Infill: 15%