Mister Pi FPGA R2 "MegaPack" Case 3mm flatpack (3D printed, ignore the photo)

Fully 3D printed version.

This is for the latest MegaPack R2 release (fall 2024); specifically I ordered my board on Nov 18, 2024.

- Also added better 3D printed buttons
- Also added some “hollow standoffs” if you don't have extras for the top, and would rather just use a longer m3 (16-20mm) bolt (like me).

The (16-20mm) m3 bolts OR (12mm) standoffs + shortm3bolts are the only part you should need that isn't printed or lasercut outside of what comes in the original megapack (use the megapack-included phillips screws on the bottom)

See here for the lasercutter version

PSA: I have not actually printed this since I woodcut mine, but it should be identical.

This is a remix of my own model.
I essentially took the svg from the other file, and extruded it 3mm into flat plates.