Mount for a brush

Bracket for a broom handle.
There was a need to use a wide outdoor brush to remove snow from the roof of a greenhouse and a bus. At the same time, it was necessary that the angle of the brush plane to the handle was about 70-80 degrees, since in this case it is more convenient to rake snow from surfaces located above human height, and the edges of the brush do not scratch the roof.
Printed from PETG. Layer 0.2 mm, 4 walls, infill 30%, adaptive cuboid, without supports.
The model is printed with the back plane (the side from which the handle is inserted is inserted into the hole) on the table.