Tall Headphone Stand

These stands are my first original uploads. I used the makerbot headphone stand for quite some time, and gradually found changes I wanted to make for an improvement. I also designed it specifically for ease of printing. No supports are needed and the chamfered edges should give a good finish on any machine or layer height. This design is the tallest I could print on my MK3, and can hang most large gaming headphones. I also added a hanger for loose cables.

Print instructions

This print does not require any supports, a brim is suggested

Any layer height will work, 0.2mm or 0.3mm will print fastest

The print weighted is about 165g - 250g depending on print settings

2 perimeters and 10% infill should be strong enough for any headphones. If you like to slam down your headphones then maybe for 3 perimeters and 20% infill would be better