CornerBuddy XL Enclosure Mount for Buddy3D Camera

Small ( < 20g! ) mount that keeps the light source behind and the camera out of the way of the toolheads. Assembled with one M4 heat set insert. 

Secure in corner by first pushing through the two side pegs and then securing the heat set insert with an M4 screw. Face the Buddy3D logo toward yourself when setting the camera on the mount. The fit will be a little tight, but that is by design. Once on, rotate the camera body clockwise 90 degrees so the Buddy3D logo is now facing down. The USB-C port should now be facing up, and you can run your power cable with the LED strip and wiring. Finally adjust the camera sensor to point at the bed.

Printed in PCCF, but I've also included files for PETG and PETGCF.