Klein Wire Crimper Skadis Mount - No Hardware Required

The original model posted by @Paradox is great, but it requires the use of M2 screws and nuts. I wanted a version of this tool holder that didn't require any additional hardware to use. I added two hooks on the back that will fit onto the Skadis board straight from the printer.

The crimping tool can be stored with the handle OR the business end facing up. With the jaws facing up, the tool locks into place nicely. With the handle pointing up, it rests securely in the mount, but is easier to remove when using the tool frequently.

Hopefully this improves the accessibility of this model a bit. Happy organizing, and don't forget to enable supports for this one!

I printed in PETG.

• .2 layer height
• auto tree supports (for the hooks

Added hooks to the model to eliminate the need for M2 hardware.