Christmas Tree

Some post processing required. Just print the Tree Top if you want to test it out.

• Print settings for Trees: 0.3mm layer height, 0.3mm first layer height, Wall Generation: Arachne
• Print settings for Stand/Star/Baubles: Any
• The model is pre-supported and you will have to peel away the support structure after printing
• Trim away any remnants using scissors - try not to leave too much support structure behind when tearing away!
• Split into three parts that can form a mini, medium or large size christmas tree.
• Mini size (Tree Top, Mini Stand)
• Medium size (Tree Top, Tree Middle, Stand Middle) - About 250mm tall including star and stand, 120mm base, Max overhang: 50mm
• Large size (Tree Top, Tree Middle, Tree Base, Stand Base) - About 370mm tall, 180mm base, Max Overhang: 65mm.

• Additional branches are included for hanging ornaments. Print them out and clip them around the trunk, between the gaps of the leaves. Should only need 2 for each of the middle and base sections.
• Ornaments need a minimum 3mm hole to hang off the branch

Some nice ornaments here