Prusa MK3 Y-Rod holder (uses original hardware)

(- Update - 5. 6. 2019 - y-rod_holder_part_2_for_2-3mm_thick_nut.stl has been added for square nuts with thickness of 2.3mm)

(- Update - 21. 5. 2019 - y-rod_holder_part_1 has been updated with lower brace that inserts into the aluminum extrusion T-slot)

(- Update - 17. 5. 2019 - Better spacing between part 2 and the Y-carriage, Square nut slides into Part 2 a bit better force is still needed for a snug fit)

Print using 9 Perimeters.
Use supports from bed only

This Y-Rod holder clamps the rods securely and uses the same hardware as the original mk3 Y-Rod holder.

--Assembly--
-The square nut slides into Part 2 will require a little bit of force.

-(IMPORTANT STEP - Snap part 1 and 2 together and screw it tight to seat the nut proper)

-You will need to squeeze the sides when screwing to the frame

Print instructions

Print using 9 Perimeters.
Use supports from bed only

--Assembly--
-The square nut slides into Part 2 will require a little bit of force.

-(IMPORTANT STEP - Snap part 1 and 2 together and screw it tight to seat the nut proper)

-You will need to squeeze the sides when screwing to the frame