Pedal Haptic Motor Mount Prototype

This is a prototyped motor mount for T300 pedals. The motors used in this model are the haptic feedback motors from the Xbox One controller. 

There are slots to use zipties to hold the motors in, but be careful, as the outer holes need to be redesigned, to much tightening will break the hole.

The bolts are M4s, I found M4x12 work fantastic, perfect length. 

G29 version is posted, but needs test fit.

SRP Lite version is posted, but needs test fit. It uses M5X8 bolts and M5 Washers. If the standoff is already in use, you will need to use a longer bolt, I would imagine an M5x14-M5X18, with an M5 nut on the mount side