Skipping Rope Handle with 608 Bearing

Skipping Rope or Jump Rope Handle

It features a standard 608 skateboard bearing. It is held together using four self-tapping wood screws. Each handle consists of three parts, the front and back of the handle and the knot holder.

The picture shows one of the handles after seven months of use so it's a bit battered but still working perfectly fine.

Printing

• Printed a full set of two handles together in one print.
• 0.20mm QUALITY
• Generic ABS
• Supports: Everywhere
• Infill: 30%
• Print Time: 13h5m

Assembly

• The rope is 4 mm in diameter
• Cut the rope to length
• Mount knot holders in the bearing 
• Put the bearings and knot holders on the rope
• Tie a knot at the end of the rope and put into the cup of the knot holder.
• Stop the knot from untying by either using, superglue on the knot, or if nylon rope is used the knot can be melted slightly.
• Screw two shells together using 3.5mm x 20mm self-tapping wood screws (ensure Screws do not protrude through the shell)