Raspberry Pi 3 Wall Mount Case

Wall mountable case for the Raspberry Pi 3(B/B+). I wanted something I could mount in my enclosures and have power soldered directly to the GPIO pins.

Update: 05/09/22

• Added v2 to the case models to increase the spacing of the MicroSD card slot.

Parts:
3 x M3 Nuts
3 x M3 8mm Bolts (Lid)
4 x M3 6mm Bolts (Case)
1 x 2.1 MM 5A DC Power Jack Socket Threaded Female Mount Connector (https://amzn.to/2FXTKHy) - Optional with Case choice.

Models:

Case with Power Option in the rear of the case.
1 x 1-RPi3_Case_v2.stl
1 x 1-RPi3_Case_Lid_v1.stl

Case with power option in the front of the case.
1 x 2-RPi3_Case_PowerFront_v2.stl
1 x 2-RPi3_Case_PowerFront_Lid_v1.stl

A smaller version of the case, no power option.
1 x 3-RPi3_Case_Small_v2.stl
1 x 3-RPi3_Case_Small_Lid_v1.stl

Print instructions

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20

Filament: Inland PLA Orange/Yellow
Notes:

Print Settings:
Prusa Slic3r - Generic PLA

Post-Printing

1. Insert the RPi into the case at an angle to align
   • 
2. DC Power Jack Socket & tighten into the case.
   •  
3. Use M3 6mm bolts to secure RPi to the case.
   • 
4. Solder DC Jack wires to the correct GPIO pins for power.
   • 
5. Insert M3 nuts in the case lid, and press to fit. (Optional: Add a drop of super glue to secure)
   • 
6. Install the case lid and insert the 8mm bolts/screws
   •