FLSUN T1/Pro LED Cover

I find the images from the factory-supplied camera to be much too bright. I'm currently using a different camera, also with a low-light chip, but the problem remains.

The LED cover is 200 mm long and can block up to 80% of the light.

About 17g of filament is required for printing, I recommend PETG or something similar, PLA quickly reaches its limits at build chamber temperatures of around 50°C.

The following is required for assembly:
- 2.0 HEX screwdriver
- 200 mm double-sided adhesive tape
- Craft knife similar to a scalpel

(The figures are intended to illustrate the overexposure when there is too much light. The angel and devil were printed on my T1 and the beachlady on my J1.)