Ruger MK-4 Rearward RMR plate

wanted my RMR to sit as far back as possible but couldnt find a model that mounted it that way. made 2 different variations, mainly due to my middle screw on the top of my mk4 becoming stripped. May need to scale up or down a few percent to get it to fit right with the RMR. I'd recommend printing this in PLA+ or better. Should work with the factory 6x48 screws that ship with the railed models. RMR uses 6x32 screws to attach to the plate. Recommend printing with PLA+.

changed reinforcement locations to match with ejection port. changed bolt pattern to allow it to sit on the rear MK-4 bolt. changed tolerances to allow interchangability with stock mk4 lite rail screws. removed engraving as I had issues with it looking awful on my prints