Bridge_test_angled

 I recently changed from Marlin to Klipper and noticed an issue with my bridging. I made this model to check different length bridges as well as bridge angles. 
This tool will help you dial in your bridge settings and diagnose issues with the parts cooler.

Test print was done at:

.2mm layer height
2 top and bottom layers
2 perimeters.

This should yield 4 side by side passes for each bridge and 1 top layer bridge.

25-50mm angles tested include:
0, 45, 90, 135, 180, 225, 270, & 315 degrees at 45 degree increments

100mm angles tested include:

22.5, 67.5, 112.5, 157.5, 202.5, 247.5, 292.5, & 337.5 degrees at 45 degree increments.