1/10th scale Willy's jeep

General information

This is a 1/10th scale rc crawler that I designed.

This is a rear steer rc car based off of a Willy's jeep using axial scx10 II parts.

The wheelbase is much shorter than the average rc car, it is a Willy's jeep after all

Parts needed (ish)

2 axial scx10 II axles (Both front)

a set of links with a way to shorten the rear link

a lot of m3 screws 10mm 8mm and 20mm, mostly

Wheels and tires (1.9)

axial 3 gear transmission

esc

receiver

Proline shocks, yes they aren't cheap but they have the softest spings. This truck is light, all the weight comes from the axles and tires

Something thin like welding wire to connect the two sides of the cage to each other.

Currently this is the original build. I can make some instructions later on and a exact BOM for anyone interested. 

Can be printed on any printer with about 220mm cubed

There isn't anything I didn't change. It was only used as a starting point.