Drywall Hole Plugs

I needed to clean up/fix a couple of holes in my bathroom wall where I used to have a towel rack. The holes were larger than just a small screw hole as I had used screw in anchor nuts. Also since the holes were through existing wall paper I didn't want to fill the holes with drywall compound/spackle because it would not look finished without completely replacing the existing wallpaper.

I've included three sizes, each fits a different hole size but the outside cap is always the same. 

The plugs are removable in the event of removing the wallpaper I could fill the holes properly with drywall compound then and paint or wallpaper over the then fixed wall.

I didn't spend any time optimizing my printer settings to get the results cleaner but as the caps are removable I could always try again when I have more time. If I do try printing cleaner caps later, I will also revise them so the caps are slightly offset from the centreline of the posts to make it easier to vertically align the exposed caps during installation.

My models are not to be shared on any 3D Model website that requires the user to create an account to access models. I.E. the model is NEVER to be shared on sites such as Cults3D or similar.