Wall mounted Kirkland/Costco Pate wet cat food despenser.

Wall mounted despenser for Costco Pate wet cat food.

Print is tall enough to fit an entire 45 count box with three separate sections to hold each flavor separately. 

Printed as is the print maxes out a Neptune 4 Max on Z height (480mm) but since the print is basically just a tube, you can remove as much Z height as needed to fit your printer without changing the functionality of the print.

I would highly recommend reducing Z height by removing the top of the print in a CAD software instead of just reducing the Z height in a slicer as this would also reduce the size of the bottom opening and in turn possibly causing issues with removing cans of food.

I found it's quickest to load from the bottom by pushing the bottom cat food can up with a new can and pushing back. (Sort of the opposite of loading a magazine for the American folks)

Picture of the prototype steps to get to the final project included for fun.

Used the original model as a size guide for creating the holes in the despenser.