Joins Printer Filament
print in resin, use a pre heated heat gun on join area for a few seconds to join. separate the halves and done. Best used for High Temp Resin, however the time under heat is very little compared to the bait molds that take 350 plastic. DO NOT OVER HEAT like a crazy man and a welding rod. make sure to use caution as it will be hot where it was hit with the heat gun, small nozzle heat guns work the best. comes in 2 halves, thinner one is on top and where heat is applied. the thicker of the 2 is the base.
please consider the 0.99 cent one to help me out on my cults page under Beards3Dprinting.
The author marked this model as their own original creation.