Source 4 Luminaire for GU10 LED Bulb

This design is from a request on my GU10 Parcan model (https://www.thingiverse.com/thing:2431893).

The only part that needs supports is the base.

Additional parts required:
1x GU10 bulb holder
2x 15mm M3 nuts and bolts (for securing base, body and bracket together)
2x 15mm M3 nuts and bolts (for GU10 holder)
--OR--
2x 25mm M3 nuts and bolts (for GU10 holder and rear cover)

EDIT 1: I realised that my original model was mirrored, so I have uploaded an accurate mirrored version, as well as a vented version to help with heat dissipation.

Edit 2: Added a rear cover to conceal wires and direct them to exit from the bottom

This is still a work in progress, as I need to add the long body version.

Post-Printing

Assembly

You will need to embed the 4 nuts in the appropriate places - 2 on the inside of the body, and 2 on the back of the base (or the cover if you are using it).

Next, insert the GU10 holder into the base by threading the 2 wires through the plain holes, and pulling them through to seat the holder in position. If you are using the rear cover, insert the 2 25mm M3 bolts through the GU10 holder, and line the wires up with the recesses in the cover and tighten the bolts.

Slide the shutters over the body, and then the body assembly slides into the base. Ensure that the orientation of the holes is correct and that they are aligned.

Place the bracket in position, and thread the 2 15mm M3 bolts through the bracket, body and base assembly.

Fit your GU10 bulb, and you're done :)