Low-profile DIN rail clip

This DIN rail clip has a pull tab to release it from the rail. A flathead screwdriver or Allen wrench can be used to pry/hook and pull the tab.

Spacing between holes is 31mm.

Triangle symbol on the clip shows correct orientation with the mount.

Required parts:

• 2x M3x5x4 brass insert (Voron BOM standard insert) (example: Cnckitchen store)

DISCLAIMER: This model has very tight tolerances around the release tab, make sure your printer is well-calibrated to have a fully functional print.

Print settings:

• 0.2mm layer height
• 4 wall perimeters
• 4 top/bottom layers
• 40% infill
• Currently only tested with ABS/ASA and PETG

The main goal was to reduce its height as much as possible. Due to its low height, the locking mechanism had to be completely redesigned not sacrificing its rigidity. Props to original the creator for making a very good design.