Prusa Enclusure Top Mount Front Bowden Tube holder

This is a mod for MandicReally's design. I needed to run a 3K spool and used his original setup. I found that since my enclosures are kinda high, feeding the filament into the bowden tube was kinda a difficult due to my short arms. 

This relocates the PC4-M10 Pneumatic Coupler and the bowden tube to the front of the enclosure. 

The threads are included in the file so use fine detail prints. Also included is the Solidworks file if you would like to change any of the specs.

___________________________________________________________________________________________________

Parts needed:

• Qty 1 - M3x4 bolt (found in the extra parts for the enclosure kit)
• Qty 1 - M3nS nuts (found in the extra parts for the enclosure kit)
• ABS recommended or PETG Filament

___________________________________________________________________________________________________
 

Recommend Print Settings:

• Material ABS recommended or PETG
• .10mm Layer height
• 15% infill
• No supports

All parts are the original design, I have included a new part to relocate the bowden tube to the front of the case.