Tangara Quad Lock Back

See the Tangara here: https://www.crowdsupply.com/cool-tech-zone/tangara

This adds a Quad Lock-compatible back to the Tangara music player. I did not create the back of the player itself; this is the back plate of the latest (V3, at the time of this post) version of the case. You can find the original here:

• https://git.sr.ht/~jacqueline/tangara-hw/tree/main/item/case/artefacts/CTZ-1-3%20Case%20Rev-03

Since the Tangara is scheduled to begin shipping in December of ‘24, I can’t test this to make sure it fits the actually device yet; that being said, this is the official case file, with one layer's worth carved out of it, so it should fit just fine.

Assembly

Print out the case on its back and the Quad Lock adapter in whichever orientation works better for your printer. I printed it on its back because I my printer handles overhangs quite well, but it's okay if this part requires supports.

Superglue the Quad Lock adapter to the mild depression in the back of the case; this is both for enhanced glue contact and to help you line up the two pieces so they look good. Fiddle with it until it looks right.

Set it aside for a while to dry, make sure it fits on your Quad Lock accessories, then tear into your Tangara to make it compatible with the Quad Lock system! Best of luck!

Sliced off the bottom plate to cut down on extra height.