8BitDo SN30 Pro Bluetooth Gamepad Mario Piranha Plant Charging Dock

Use this pipe sleeve and cable router in combination with all other plant pieces (tongue, teeth, pringles pipe topper, spots, and original gums) here: https://www.printables.com/model/502103-piranha-plant-piggy-bank-lid to create a Mario themed charging dock for your 8BitDo controllers.

Included are two types of pipes versions with docks for 2-6 controllers.  

• Route the USB cable out the mouth: Print the regular pipes and the plant “gums bigger mouth hole” included here.
• Route the USB out the bottom side of the pipe: Print the pipe version named “bottom cable hole” and the regular “gums” from https://www.printables.com/model/502103-piranha-plant-piggy-bank-lid 

You can stand the dock upright or have it laying down flat. I included a small “base chip” which can be superglued to the bottom of one side of the pipe to keep it from rolling over when using it on it's side. When using it upright, you may have to add some extra weight to the bottom of the pipe so that it doesn't tip over with the weight of the controllers. You can experiment with printing the pipe at 100% infill or adding in some weights mid-print, but I haven't tried it myself. 

Print Details

• 15% infill
• No supports
• 0.2 Layer Height
• Print 1x copy of a pipe with the desired cable routing and number of docks.
• Print as many copies of the cable router as the number of docks you want.
• If you want to lay the pipe on it's side print a base chip.
• Slide the USB C cable head into each of the cable router slots
• Slide the cable routers into the pipe sleeve from the open end. 
• Add the pipe end with plant topper. You may have to super glue the plant parts together for the best fit.

Use this cable to create a 6x charging dock: 
Multi Charging Cable, USB C Splitter Cable 1.5ft, 6 in 1 USB 2.0 A Male to 6 USB C Male Charging Cord Compatible with Cell Phones Tablets and More
https://a.co/d/5wuSuN3 

If you're interested in remixing this model here is the Onshape link: https://cad.onshape.com/documents/9bbe4473ff745e347de37847/w/cebd206e7cfb2d5d3b736a6f/e/110563b34ed14c3776fa39a4?renderMode=0&uiState=67454a996162a96fb0e707e3 

The mouth opening is slightly larger to allow a USB cable to run through it, and the base is slightly larger to fit more snug into the pringles lid.