Raspberry pi NAS case (yes, an other one)

This isan other Raspberry pi NAS cas design. This case:

• can hold up to 2 2.5" disks
• has provision for a 40mm fan (The cables route close to the fan, but it works.)
  Note: I tried the case with a Raspberry pi 3, it should work with other models

The fans blows air in the case which can only leave via the holes in the disk and pi side. It is not hte best cooling solution, but for home use it works well.
(The 5V fans can be connected directly to the 5V & GND pin on the PI)

Required fasteners:

• 4 M3*8mm blots per hard disk
• 4 2.7*8mm self tapping screws for the pi
• 4 2.7*8mm self taping screws to attache the feets to the cover
• 5 2.7*8mm self taping screws to fasten the cover to the base
• 4 M4*14mm bolt with nut (or 3d printing M4 insert)

I included the FreeCad file :)

Happy printing

Eddit:
- I updated the rack design to V2. The holes on the HDD side are lowered to improve the airbow on the pi side and I added some break in provisions to fit a network cable to the case.