GEP Standard switchplate cover

I couldn't find any downloads for this brand/model so I applied my calipers and almost-nonexistent CAD skills to design my own. Dimensions are almost dead-on, but I replaced the curved edges with more print-friendly chamfers.

Printed at 0.2mm layer height with 15% honeycomb infill and first-layer infill set to Octagram Spiral. My phone camera struggled with these colours (blue/green silk PLA), honestly looks better IRL.

Prints ok face-down without supports so long as your cooling is decent, but I did get a bit of curling on the corners. You could also print face-up with support if your top-layer/ironing is dialled. If I ever get around to v2, I'll probably go with steeper/smaller chamfers and a slightly thinner face to sit more flush with the switch and eliminate the infill layers. 

OnShape project here if anyone needs it, not parametric but simple enough to figure out if you wanna remix.