About this case:
My components:
Standard components you will need:
Component | Qty |
Cylindreical magnets 5x2 | 16 |
Screw DIN 912 M3x5 | 2 |
Screw DIN 912 M3x8 | 6 |
Screw DIN 912 M3x10 | 11 |
Screw DIN 912 M3x12 | 4 |
Screw DIN 912 M3x14 | 4 |
Screw DIN 912 M3x16 | 10 |
Nut DIN 934 M3 | 31 |
Standoff screws M3x6+6 | 4 |
Screws for motherboard | 4 |
Power button (thread Ø = 12mm) | 1 |
Riser cable 90° (length 250-300mm) | 1 |
In the future I will add full instructions for assembling this PC case.
Print settings for all models:
A1 - Case handles
Set supports setting to: For support enforcers only.
Use Paint-on supports tool (Tool type: Smart fill) and select the faces shown in the image.
Enable Brim (Brim type: Outer and inner brim).
A2 - Case (№1)
Set supports setting to: For support enforcers only.
Use Paint-on supports tool (Tool type: Smart fill) and select the faces shown in the image (Supports should only be in ventilation holes).
Enable Brim (Brim type: Outer and inner brim).
A3 - Case (№2)
Set supports setting to: For support enforcers only.
Use Paint-on supports tool (Tool type: Smart fill) and select the faces shown in the image (Supports should only be in ventilation holes).
Enable Brim (Brim type: Outer and inner brim).
B1 - Central part (№1)
Support and brim not required for this part.
B2 - Central part (№2)
Support and brim not required for this part.
С1 - PSU holder (Fastener of central parts (№1))
Set supports setting to: For support enforcers only.
Use Paint-on supports tool (Tool type: Smart fill) and select the faces shown in the image (Supports should only be in ventilation holes).
С2 - Fastener of central parts (№2)
Support and brim not required for this part.
D1 - Ventilation grille
Support and brim not required for this part.
(You need to print 2 pcs.)
E1 - Graphics card holder
Support and brim not required for this part.
E2 - Riser cable holder
Set supports setting to: For support enforcers only.
Use Paint-on supports tool (Tool type: Smart fill) and select the faces shown in the image (Supports should only be in ventilation holes).
A1 - Case handles
Remove the supports.
Cut the bridge shown in red in the image.
A2 - Case (№1)
Remove the supports and brim.
Drill the holes shown in red in the image.
A3 - Case (№2)
Remove the supports and brim.
B1 - Central part (№1)
Drill the holes shown in red in the image.
B2 - Central part (№2)
No post-processing required for this part.
С1 - PSU holder (Fastener of central parts (№1))
Remove the supports.
С2 - Fastener of central parts (№2)
No post-processing required for this part.
D1 - Ventilation grille
No post-processing required for this part.
E1 - Graphics card holder
No post-processing required for this part.
E2 - Riser cable holder
Remove the supports.
P.S. KKP means Kakapo. This is a rare and endangered parrot species found on several islands in New Zealand. They are very cute.
The author marked this model as their own original creation.