I found these lights at a second hand electronics store, they ended up being the exact length of my printer frames, Made these small clips to attach them to the frame. I used these Fasteners to attach them to the T frame. 2 different mounting for the brightness dial. Used double sided foam tape to attach the dial to the bracket
Hardware used are M4*8mm/10mm ; M4 T-Slot Nut
For the Dial_End_Bracket, I had to cut down two of the pegs to make room for the frame screw
RECOMENDED- when the clips are freshly done printing, they will be a little more flexible. I took this time to snap them onto the lights, This issue can probably be avoided printing in PETG.
Made 2 versions of the Dial Mount, The extrusion end cap style. Or frame mounted with the fasters style.
Everything was printed with OVERTURE PLA.
Standard Print Settings,
Light Clips 100% infill
Dial Bracket 30% infill
https://a.co/d/21k2PYE -Lights used for this project
https://a.co/d/dVYqE5l -Metric Screw Assortment
https://a.co/d/fvVKV8v -Hammer Head Fastener
The author marked this model as their own original creation.