Minimalist Framework Mainboard Case, 2-piece, Optimized Airflow

A minimal case for the Framework Mainboard.

Prints in only two pieces, unlike most, and fits on a standard MK4 print bed (or equivalent size).

In the name of minimalism and size, this case has no support for the USB modules, audio board, battery, or wifi card. Mainboard only, compact and slim.

The airflow is designed so the fan pulls cool air from the far side of the case, cooling other components on the board such as the RAM and SSD. My personal Mainboard stays within a good operating temperature, however I'm not a thermal engineer, I can't guarantee this design is any better or worse than an open design. Use at your own risk.

Print flat, no supports, 100% infill, 3 perimeters.

Assemble with 6x M2 screws and nuts.