Toothbrush Holder - Smiling Tooth

A small improvement/remix of @PsychProd gorgeous model of Smiling Toothbrush Holder.  
It fixes some strange artefacts and empty internal pocket in the model. It also widen model to fit kids electric toothbrush “Bob a Bobek” and toothpaste.

Printed model size is 85mm x 85mm x 127mm.
Toothbrush pockets: 61mm x 25mm x 80mm & 61mm x 34mm x 78 mm

Print recommendation

This model can be printed without supports if your printer has sufficient cooling and you can live with some unperfect overhangs.
I have also painted supports on the bottom of the model if you are not brave enough to run it without them =)

I strongly recommends adding brim (7mm or more) to the feets so they will hold better to the printers bed.

I would also suggest to slow down printing speed (acceleration, travers speed, etc.) on Bed Slinger printers for at least until tooth feets merge together.

Print Settings

Printer: Bambulab A1 Mini

Brim: Yes

Supports: No

Resolution: 0.2 (with adaptive layer height on top)

Infill: Gyroid 10%

Filament: eSUN PLA+ in White colour

I have improved/remixed gorgeous model smiling_toothbrush_holder_simple_partition.stl in Blender to achieve these goals:

1. Fixed unconnectable edge.
2. Remove internal edges from the mesh that produced strange artefacts (triple wall) and empty pockets in the model after slicing. (see image)