Magnetic door closer

A pair of prints with space for embedded 17mm*4mm magnets to be screwed onto a latchless door and its frame to provide enough force to hold the door closed (and even pull them together when close enough) but light enough to easily be opened by a person with intent

Designed to print without supports

Recommended print orientation according to picture (if printing this way, magnet heights line up so you can insert them both in the same layer-pause command. Make sure you get the orientation of the magnets right! The bent piece is meant to be installed upside down from print orientation in the picture)

Screwholes are countersunk so you know which way round they're meant to be installed