50 mm Pipe wall support

I made this to hold up a pipe on my wall which was previously held up by a nail and some wire. This print allows you to hold the pipe in place while drilling/screwing above and below it.

The main thing for me was i did not want to remove the pipe to add this fitting so i made it so its also possible to insert and install without touching the pipe you are securing.

Pipe size 50mm
Hole for screws 4mm

I printed it with a 50% infill for strength

✨If you like what I make ✨

• Like, follow, comment, share, review, and post your makes
• Check out my other models! :)