A single gauge pod that replaces the existing dash vent in any Subaru Impreza WRX/STI 08-14.
For left hand drive, you can mirror the model in your slicer.
Material: Ensure to print with a higher temperature resistance material. PLA likely will melt in sun.
Printing Time: 1hr37m
Filament Used: 33.19g
How to print: Orientate model as shown ↓
How to Install:
Step 1: Unclip and remove existing dash vent. Route gauge wiring under the dash and through the vent opening.
Step 2: From the rear of the model, feed the wiring through the square hole and up to the gauge pod enclosure.
Step 3: Plug in necessary wiring to your gauge.
Step 4: Press fit your gauge into the pod and insert the pod into the vent pressing firmly. Enjoy!
The author marked this model as their own original creation.